6″ diameter screw x 12′ long with 2/3 pitch inlet flighting, balance full pitch flighting, Carbon steel construction, Interior surfaces uniform mill finish, Continuous weld on both sides of flighting, Welds in contact with product are continuous, Welds not in contact with product intermittent, gaps filled with Devcon, Mild Steel Portable base with two (2) rigid and two (2) swivel casters with brakes and hydraulic jack for angle adjustment, 5 1/2 cu. Ft Nominal capacity hopper with bolted safety grating, 6″ Standard pipe stub discharge with lip for flex boot, Exterior mild steel components to be one coat primer & one coat (blue), Double lip seal on the drive and single lip seal on discharge end, 2 HP, 1800 RPM 3/60/230-460V TEFC (4:1) Inverter duty motor, 10:1 gear reducer for a auger speed of 175 RPM, Standard cleanout with 120 VAC limit switch (mounted not wired), Controls, Wiring and installation by customer.